Nissan Stanza Workshop Manuals and Repair Manuals

To change the oil in a Nissan Stanza, you will need to locate the oil drain plug underneath the car and remove it to drain the old oil. After draining the old oil, replace the drain plug and remove the oil filter. Install a new oil filter and add the recommended amount of fresh oil to the engine. Remember to dispose of the old oil and filter properly.

To check the transmission fluid in a Nissan Stanza, park the vehicle on a level surface and start the engine. With the engine running, shift the transmission through all the gears and then put it in "Park." Locate the transmission dipstick, usually near the back of the engine compartment, and remove it. Wipe the dipstick clean, reinsert it, and then remove it again to check the fluid level. The fluid should be within the designated range on the dipstick. If it is low, add the recommended type of transmission fluid slowly through the dipstick tube.

If you are experiencing a power window issue in your Nissan Stanza, start by checking the fuse for the power windows in the fuse box. If the fuse is blown, replace it with a new one of the same amperage. If the fuse is intact, check the window switch for any signs of damage or malfunction. If necessary, replace the window switch assembly. Additionally, inspect the wiring and connections for any loose or damaged components. If the issue persists, it is recommended to have a professional diagnose and repair the power window system.

To jump-start a Nissan Stanza, you will need a set of jumper cables and a second vehicle with a charged battery. Park the vehicles close enough for the jumper cables to reach both batteries. Turn off the ignition and connect one end of the positive (red) jumper cable to the positive terminal of the dead battery and the other end to the positive terminal of the charged battery. Connect one end of the negative (black) jumper cable to the negative terminal of the charged battery and the other end to a metal surface on the engine block of the dead vehicle, away from the battery. Start the engine of the vehicle with the charged battery and let it run for a few minutes. Then, try starting the Nissan Stanza. Once it starts, remove the jumper cables in the reverse order of how they were connected.

To perform a basic engine tune-up on a Nissan Stanza, start by replacing the spark plugs, ignition wires, distributor cap, and rotor if necessary. Inspect and replace the air filter and fuel filter if needed. Check and adjust the ignition timing and idle speed if applicable. Clean the throttle body and fuel injectors to improve fuel delivery

To replace a brake pad in a Nissan Stanza, start by safely lifting the vehicle and removing the wheel. Locate the brake caliper, which is typically held in place by bolts or slide pins. Remove the bolts or slide pins and carefully lift the caliper off the brake rotor. Slide out the old brake pad and replace it with a new one, making sure it is properly aligned. If necessary, compress the caliper piston using a C-clamp or a brake caliper tool. Reinstall the caliper, tighten the bolts or slide pins, and then repeat the process for the other brake pad. Finally, reinstall the wheel and lower the vehicle.

To replace the cabin air filter in a Nissan Stanza, locate the cabin air filter housing, which is usually located behind the glove compartment or under the dashboard on the passenger side. Open the housing by removing the screws or clips that hold it in place. Take out the old filter and replace it with a new one, making sure it is properly aligned. Close the housing and secure it with the screws or clips. It is recommended to replace the cabin air filter every 12,000 to 15,000 miles or as specified in the owner's manual.

To replace a fuel filter in a Nissan Stanza, locate the fuel filter, which is typically located along the fuel line underneath the vehicle. Use a wrench to loosen the fittings and carefully disconnect the fuel lines from the filter. Remove the old filter and install the new one, making sure the flow direction arrow on the new filter is pointing towards the engine. Reconnect the fuel lines and tighten the fittings securely. Start the engine and check for any fuel leaks.

To replace a headlight bulb in a Nissan Stanza, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector from the bulb by gently pulling it off. Remove the retaining clip or ring that holds the bulb in place. Carefully remove the old bulb and replace it with a new one, making sure not to touch the glass part of the bulb with your bare hands. Reinstall the retaining clip or ring, and then reconnect the electrical connector.

To replace a serpentine belt in a Nissan Stanza, locate the belt routing diagram, which is usually found under the hood or in the owner's manual. Use a wrench or a belt tensioner tool to relieve tension on the belt and remove it from the pulleys. Install the new belt following the belt routing diagram, making sure it is properly seated on each pulley. Release the tensioner and double-check the belt's alignment. Finally, start the engine and inspect the belt for proper operation and alignment.

To replace a thermostat in a Nissan Stanza, locate the thermostat housing, which is usually attached to the engine block and connected to the radiator hose. Drain the coolant from the system until it is below the level of the thermostat housing. Remove the bolts holding the housing in place and carefully lift it off. Take out the old thermostat and replace it with a new one, making sure the spring side is facing into the engine. Clean the mating surfaces of the housing and engine block, then reinstall the housing and tighten the bolts securely. Refill the cooling system with the appropriate coolant mixture.

If your Nissan Stanza is overheating, start by checking the coolant level and ensuring it is at the correct level. Inspect the radiator and cooling system for any leaks or blockages, and address them accordingly. Check the operation of the cooling fans and make sure they are functioning properly. Additionally, inspect the thermostat, water pump, and radiator cap for any signs of damage or malfunction. If the issue persists, it is recommended to have a professional mechanic diagnose and repair the problem.

The spark plugs in a Nissan Stanza should be replaced every 30,000 to 50,000 miles, or as recommended in the owner's manual. Worn or fouled spark plugs can cause engine misfires, reduced fuel efficiency, and poor performance. When replacing the spark plugs, make sure to use the correct type and gap specified for your vehicle.

The recommended tire pressure for a Nissan Stanza can be found in the owner's manual or on a sticker located on the driver's side door jamb. It is important to maintain the proper tire pressure to ensure optimal handling, fuel efficiency, and tire wear. Check the tire pressure regularly and adjust it as needed using a tire pressure gauge and an air compressor.

Nissan recommends using a high-quality ethylene glycol-based coolant with corrosion inhibitors for a Nissan Stanza. This coolant should be mixed with distilled water in a 50/50 ratio before adding it to the cooling system. Avoid using plain water or incompatible coolants, as they can cause damage to the engine and cooling system components.