Nissan Rogue S35 Workshop Manuals and Repair Manuals

To change the air filter in a Nissan Rogue S35, locate the air filter housing, usually positioned on the driver's side of the engine compartment. Unclip the housing cover and remove it to access the air filter. Take note of the orientation of the old filter, remove it, and clean any debris from the housing. Insert the new filter, ensuring it is properly aligned, and securely reattach the housing cover.

To change the cabin air filter in a Nissan Rogue S35, locate the filter housing, usually located behind the glove compartment. Open the glove compartment and remove any contents. Release the glove compartment stops and lower the compartment to access the filter housing. Unclip the filter cover, remove the old filter, and clean any debris from the housing. Insert the new filter, ensuring it is properly aligned, and reassemble the components in reverse order.

To check the transmission fluid level in a Nissan Rogue S35, ensure the vehicle is parked on a level surface and the engine is warmed up. Locate the transmission dipstick, usually labeled with a yellow or red handle. Remove the dipstick, wipe it clean, reinsert it fully, and then remove it again to check the fluid level. The correct fluid level should be within the designated range on the dipstick. If needed, add the recommended transmission fluid through the dipstick tube.

To jump-start a Nissan Rogue S35, park a vehicle with a fully charged battery close enough to the Rogue for the jumper cables to reach both vehicles' batteries. Turn off both vehicles and connect the positive jumper cable to the positive terminal of the dead battery and the other end to the positive terminal of the working battery. Then, connect the negative jumper cable to the negative terminal of the working battery and the other end to a metal part of the Rogue's engine block. Start the vehicle with the working battery and let it run for a few minutes, then try starting the Rogue.

To replace a battery in a Nissan Rogue S35, ensure the vehicle is turned off and in park. Locate the battery, usually located in the engine compartment. Disconnect the negative cable first by loosening the nut and sliding it off the terminal. Then, disconnect the positive cable in the same manner. Remove any retaining brackets or covers holding the battery in place. Lift the old battery out of the compartment and place the new battery in, ensuring proper orientation. Reattach the retaining brackets, reconnect the positive cable, and then the negative cable.

To replace a brake light bulb in a Nissan Rogue S35, open the trunk or rear hatch and locate the access panel behind the brake light assembly. Remove the panel by either unscrewing it or releasing the clips. Twist the bulb socket counterclockwise to remove it from the assembly. Then, remove the old bulb by pulling it straight out and insert the new bulb, making sure it is securely in place. Reinsert the socket back into the assembly and twist it clockwise to lock it in position. Replace the access panel.

To replace a headlight bulb in a Nissan Rogue S35, first, locate the back of the headlight assembly under the hood. Twist the headlight bulb socket counterclockwise, remove it from the assembly, and disconnect the wiring harness. Then, remove the old bulb by pulling it straight out and insert the new bulb, making sure it is securely in place. Reconnect the wiring harness, insert the socket back into the assembly, and twist it clockwise to lock it in position.

To replace a serpentine belt in a Nissan Rogue S35, locate the belt tensioner pulley and use a wrench or a specialized tool to relieve tension on the belt. While holding the tensioner in the released position, slide the belt off one of the pulleys. Slowly release the tensioner, allowing it to put tension on the remaining belt. Remove the belt from the other pulleys and install the new belt, following the correct routing diagram. Finally, release the tensioner to apply tension to the new belt.

To replace a windshield wiper blade in a Nissan Rogue S35, lift the wiper arm away from the windshield. Locate the release tab on the wiper blade connector and press it to release the blade. Slide the old blade out of the connector and slide the new blade into place, ensuring it is securely attached. Carefully lower the wiper arm back onto the windshield. Repeat the process for the other wiper blade if necessary.

To reset the maintenance reminder light in a Nissan Rogue S35, turn the ignition switch to the ON position without starting the engine. Within 10 seconds, press the trip/reset button on the instrument cluster until the maintenance reminder displays. Then, press and hold the trip/reset button for approximately 5 seconds until the reminder light resets. Release the button and verify that the maintenance reminder light has turned off.

The engine oil in a Nissan Rogue S35 should be changed every 5,000 to 7,500 miles or as recommended by the manufacturer. Regular oil changes are crucial to ensure proper lubrication of the engine components, prevent excessive wear, and maintain optimal engine performance. It is essential to use the recommended oil grade and quality specified in the owner's manual.

The recommended coolant type for a Nissan Rogue S35 is a long-life coolant with ethylene glycol base, preferably a pre-mixed coolant that is specifically formulated for use in aluminum engines. It is important to use the correct coolant to prevent overheating, corrosion, and damage to the cooling system components. Refer to the owner's manual or consult with a Nissan dealership to ensure you select the appropriate coolant for your vehicle.

The recommended tire pressure for a Nissan Rogue S35 is typically 33 psi. Maintaining the correct tire pressure is essential for optimal fuel efficiency, tire longevity, and overall vehicle performance. It is important to regularly check and adjust the tire pressure according to the manufacturer's guidelines.

The towing capacity of a Nissan Rogue S35 varies depending on the specific model and configuration, but it typically ranges from 1,000 to 1,500 pounds. It is important to consult the owner's manual or contact a Nissan dealership to determine the exact towing capacity for a specific vehicle. Exceeding the recommended towing capacity can lead to damage to the vehicle's transmission, brakes, and suspension.