Nissan Patrol GR Workshop Manuals and Repair Manuals

To change a flat tire on a Nissan Patrol GR, start by parking the vehicle on a safe and level surface, engaging the parking brake, and placing a wheel chock on the opposite side of the flat tire. Locate the spare tire, jack, and lug wrench, which are usually stored in the rear cargo area. Follow the instructions in the owner's manual to safely lift the vehicle, remove the lug nuts, and replace the flat tire with the spare tire.

To check the brake fluid level in a Nissan Patrol GR, start by locating the brake fluid reservoir, which is usually located near the firewall on the driver's side of the engine compartment. Ensure the vehicle is parked on a level surface and the engine is off. Remove the cap from the reservoir and visually inspect the fluid level, which should be between the minimum and maximum marks. If necessary, add the recommended brake fluid to bring the level within the acceptable range.

To check the engine oil level in a Nissan Patrol GR, start by parking the vehicle on a level surface and turning off the engine. Locate the oil dipstick, usually located near the engine, and remove it. Wipe the dipstick clean, reinsert it fully, and then remove it again to check the oil level. The oil level should be between the minimum and maximum marks on the dipstick.

To jump-start a Nissan Patrol GR, you will need a set of jumper cables and another vehicle with a fully charged battery. Position the vehicles close enough for the jumper cables to reach both batteries, but ensure they are not touching each other. Connect the positive (+) jumper cable to the positive terminal of the dead battery, then connect the other end to the positive terminal of the charged battery. Connect the negative (-) jumper cable to the negative terminal of the charged battery, then connect the other end to a metal surface on the engine block of the dead vehicle, away from the battery. Start the engine of the vehicle with the charged battery, let it run for a few minutes, then attempt to start the Nissan Patrol GR. Once started, carefully disconnect the jumper cables in reverse order.

To replace the cabin air filter in a Nissan Patrol GR, start by locating the filter housing, which is typically located behind the glove box or under the dashboard. Remove the access panel or glove box if necessary to access the filter housing. Open the housing and remove the old filter, taking note of its orientation for proper installation. Insert the new filter in the correct direction, close the housing, and reinstall any panels or components that were removed.

To replace the fuel filter in a Nissan Patrol GR, start by relieving the fuel system pressure by removing the fuel pump fuse or relay and running the engine until it stalls. Disconnect the negative battery cable, locate the fuel filter, which is typically located along the fuel line under the vehicle or inside the fuel tank. Use appropriate tools to disconnect the fuel lines from the filter, taking note of their orientation for reinstallation. Remove the old filter and install the new one, reconnect the fuel lines, and ensure they are properly tightened. Finally, reconnect the negative battery cable and start the engine to check for leaks.

To replace a headlight bulb in a Nissan Patrol GR, start by opening the hood and locating the back of the headlight assembly. Remove the electrical connector from the bulb, then twist the bulb counterclockwise to release it from the assembly. Carefully insert the new bulb, making sure not to touch the glass surface, and secure it by twisting it clockwise. Finally, reconnect the electrical connector and test the headlights to ensure proper functionality.

To replace the serpentine belt in a Nissan Patrol GR, start by locating the belt routing diagram, which is usually found on a sticker under the hood or in the owner's manual. Use a wrench or tensioner tool to relieve tension on the belt, then slip it off the pulleys. Compare the old belt with the new one to ensure they are the same length and have the same number of ribs. Install the new belt following the belt routing diagram, ensuring it is properly seated on each pulley, and release the tensioner to tighten the belt.

To replace a spark plug in a Nissan Patrol GR, start by locating the spark plug wires or ignition coil packs, which are usually connected to the top of the engine. Remove the wire or coil pack from the spark plug, using appropriate tools if necessary. Use a spark plug socket and ratchet to remove the old spark plug, taking note of its condition for troubleshooting purposes. Install the new spark plug by hand, ensuring it is properly threaded, and then use the spark plug socket to tighten it to the manufacturer's specifications. Finally, reconnect the wire or coil pack to the spark plug.

To reset the maintenance reminder in a Nissan Patrol GR, turn the ignition switch to the ON position without starting the engine. Within 10 seconds, press and hold the trip reset button until the maintenance reminder resets. The maintenance reminder should now be cleared, indicating that the maintenance has been performed or the reminder has been reset for the next scheduled maintenance.

The air filter in a Nissan Patrol GR should be inspected and replaced as needed. However, it is generally recommended to replace the air filter every 12,000 to 15,000 miles or every 12 months, whichever comes first. Regularly checking the air filter and replacing it when necessary ensures proper airflow to the engine, improves fuel efficiency, and helps maintain engine performance.

The recommended tire pressure for a Nissan Patrol GR can be found in the owner's manual or on a sticker located on the driver's side door jamb or inside the fuel filler door. It is important to maintain the proper tire pressure for optimal handling, fuel efficiency, and tire longevity. Ensure the tires are cold before checking or adjusting the pressure, and use a reliable tire pressure gauge to ensure accuracy.

The towing capacity of a Nissan Patrol GR depends on the specific model and configuration. Generally, the towing capacity can range from 2,500 to 3,500 kilograms (5,500 to 7,700 pounds). It is important to reference the vehicle's owner's manual or consult with a Nissan dealer to determine the exact towing capacity for a specific Nissan Patrol GR model.

It is recommended to use a high-quality ethylene glycol-based coolant that is specifically formulated for use in Nissan vehicles. This type of coolant provides effective engine cooling and corrosion protection. Before adding coolant, make sure the engine is cool, and then slowly pour the coolant into the radiator or coolant reservoir until it reaches the appropriate level.

It is recommended to use a high-quality engine oil that meets the specifications outlined in the vehicle's owner's manual. Typically, a multi-viscosity oil such as 5W-30 or 10W-40 is suitable for most Nissan Patrol GR models. Using the correct type and grade of engine oil helps ensure proper lubrication, engine protection, and optimal performance.