Nissan Murano Z51 Workshop Manuals and Repair Manuals

To change the oil in your Nissan Murano Z51, start by locating the oil drain plug underneath the engine. Use a wrench to loosen and remove the drain plug, allowing the old oil to drain into a container. Once the oil has completely drained, replace the drain plug and proceed to remove the oil filter. After installing a new oil filter, refill the engine with the recommended amount and type of oil specified in the owner's manual.

To check the brake fluid level in your Nissan Murano Z51, locate the brake fluid reservoir, which is usually located on the driver's side of the engine compartment near the firewall. Ensure the vehicle is parked on a level surface, and then remove the cap from the reservoir. The fluid level should be between the minimum and maximum markings on the side of the reservoir. If the level is low, add the recommended brake fluid type as specified in the owner's manual.

To check the tire pressure in your Nissan Murano Z51, start by locating the tire valve stems, which are usually found on the outer side of the tires. Remove the cap from the valve stem and use a tire pressure gauge to measure the pressure. Compare the reading to the recommended tire pressure listed in the owner's manual or on a sticker located on the driver's side door jamb. Add or release air as necessary to reach the correct tire pressure.

To check the transmission fluid level in your Nissan Murano Z51, start by parking the vehicle on a level surface and ensuring the engine is warm. Locate the transmission dipstick, usually found towards the rear of the engine compartment. Remove the dipstick, wipe it clean, and reinsert it fully. Then, remove it again and check the fluid level on the dipstick. If the level is low, add the recommended transmission fluid type as specified in the owner's manual.

To jump-start your Nissan Murano Z51, you will need a set of jumper cables and a working vehicle with a fully charged battery. First, position the vehicles close enough so that the jumper cables can reach both batteries. Ensure both vehicles are turned off and the parking brakes are engaged. Connect the red positive (+) clamp to the positive terminal of the dead battery, then attach the other red clamp to the positive terminal of the working battery. Next, connect the black negative (-) clamp to the negative terminal of the working battery, and attach the other black clamp to an unpainted metal surface on the dead vehicle's engine block. Start the working vehicle and let it run for a few minutes, then start the dead vehicle. Once the dead vehicle starts, carefully remove the jumper cables in reverse order.

To replace a blown fuse in your Nissan Murano Z51, locate the fuse box, which is usually located under the dashboard on the driver's side or in the engine compartment. Refer to the owner's manual to identify the specific fuse that needs to be replaced. Use a fuse puller or a pair of pliers to carefully remove the blown fuse and replace it with a new one of the same amperage rating. Ensure the new fuse is securely in place before closing the fuse box.

To replace a headlight bulb in your Nissan Murano Z51, open the hood and locate the back of the headlight assembly. Remove the electrical connector by pressing the release tab and pulling it off. Then, twist the bulb socket counterclockwise to unlock it and carefully remove the bulb. Insert the new bulb into the socket, making sure it is securely in place. Finally, reinstall the bulb socket by twisting it clockwise and reconnect the electrical connector.

To replace the battery in your Nissan Murano Z51, start by turning off the engine and ensuring all electrical components are switched off. Locate the battery, which is usually found in the engine compartment. Remove the negative (-) cable from the battery terminal, followed by the positive (+) cable. Then, remove any securing brackets or clamps and carefully lift out the old battery. Install the new battery in the same position, reconnect the positive (+) cable followed by the negative (-)

To replace the cabin air filter in your Nissan Murano Z51, start by locating the cabin air filter housing, which is usually located behind the glove compartment or under the dashboard on the passenger side. Open the housing by removing the retaining clips or screws. Take out the old filter and replace it with a new one, ensuring it is properly seated. Finally, reassemble the housing and make sure all clips or screws are securely fastened.

To replace the serpentine belt in your Nissan Murano Z51, start by locating the belt routing diagram, which is usually found on a sticker under the hood or in the owner's manual. Use a wrench or tensioner tool to relieve tension on the belt tensioner, then slide the old belt off the pulleys. Carefully route the new belt according to the diagram, ensuring it is properly seated on each pulley. Lastly, release the tensioner to apply tension to the new belt.

To replace the spark plugs in your Nissan Murano Z51, start by locating the spark plug wires or ignition coil packs, depending on the specific engine configuration. Carefully disconnect the wires or coil packs from the spark plugs. Use a spark plug socket and ratchet to remove the old spark plugs from the engine. Install the new spark plugs by hand, ensuring they are properly threaded, and then tighten them with the spark plug socket. Finally, reconnect the spark plug wires or coil packs.

To replace the windshield wiper blades on your Nissan Murano Z51, lift the wiper arm away from the windshield until it locks into an upright position. Locate the release tab on the wiper blade assembly and press it to remove the old blade. Align the new wiper blade with the wiper arm, ensuring the hook goes into the slot and locks securely. Gently lower the wiper arm back onto the windshield and repeat the process for the other wiper blade.

To reset the maintenance reminder light on your Nissan Murano Z51, turn the ignition switch to the "ON" position without starting the engine. Within 10 seconds, press and hold the trip reset button until the maintenance reminder light starts flashing. Release the trip reset button, then immediately press and hold it again for about five seconds until the maintenance reminder light turns off. The light should now be reset, indicating that the maintenance reminder has been successfully cleared.

It is recommended to replace the air filter in your Nissan Murano Z51 every 12,000 to 15,000 miles or every year, depending on driving conditions. However, it's important to inspect the air filter regularly and replace it sooner if it appears dirty or clogged. A clean air filter ensures optimal engine performance and improves fuel efficiency by allowing proper airflow to the engine.

If your Nissan Murano Z51 is overheating, the first step is to safely pull over and turn off the engine. Allow the vehicle to cool down before opening the hood. Check the coolant level in the reservoir, and if it's low, add a mixture of coolant and water as specified in the owner's manual. Additionally, inspect the radiator hoses for any signs of leaks or damage, and consider seeking professional assistance if the issue persists.