Nissan Micra K12 Workshop Manuals and Repair Manuals

Start by locating the spare tire and necessary tools, including a jack and lug wrench, as outlined in your Nissan Micra K12 repair manual. Safely position the jack under the vehicle and raise it until the flat tire is off the ground. Use the lug wrench to loosen the lug nuts, remove the flat tire, and replace it with the spare. Then, tighten the lug nuts, lower the vehicle, and ensure all lug nuts are properly tightened.

Park your Nissan Micra K12 on a level surface and allow the engine to cool. Locate the engine oil dipstick, usually marked with a yellow or orange handle, and remove it. Wipe the dipstick clean, reinsert it fully, and then remove it again to check the oil level. If the oil level is low, add the recommended oil as specified in the repair manual, ensuring not to overfill.

Park your Nissan Micra K12 on a level surface and allow the engine to cool. Locate the brake fluid reservoir, usually near the firewall in the engine bay, and remove the cap. The brake fluid level should be between the minimum and maximum marks on the reservoir. If needed, add the recommended brake fluid as specified in the repair manual, taking care not to spill any fluid on painted surfaces.

Use a tire pressure gauge to check the pressure of each tire, including the spare, when the tires are cold. Unscrew the valve cap on the tire, place the gauge onto the valve stem, and press firmly to get a reading. Compare the measured pressure to the recommended pressure specified in the Nissan Micra K12 repair manual. If needed, add or release air accordingly.

Park your Nissan Micra K12 on a level surface and allow the engine to idle. Locate the transmission dipstick, usually near the back of the engine bay, and remove it. Wipe the dipstick clean, reinsert it fully, and then remove it again to check the fluid level. The transmission fluid level should be within the designated range indicated on the dipstick. If needed, add the recommended transmission fluid as specified in the repair manual, ensuring not to overfill.

Position the assisting vehicle near your Nissan Micra K12, turn off both engines, and ensure both vehicles are in park or neutral with the parking brakes engaged. Connect the positive (red) jumper cable to the positive terminal of the dead battery, then connect the other end of the positive cable to the positive terminal of the assisting vehicle's battery. Attach one end of the negative (black) cable to the negative terminal of the assisting vehicle's battery and the other end to an unpainted metal surface of your Nissan Micra K12. Start the assisting vehicle, wait a few minutes, then start your Micra K12. Once started, carefully remove the cables in reverse order.

Locate the fuse box, typically found in the engine bay or interior cabin, as specified in your Nissan Micra K12 repair manual. Identify the fuse corresponding to the affected circuit and use a fuse puller or needle-nose pliers to remove the blown fuse. Insert a new fuse of the same rating and ensure it is securely seated. Refer to the repair manual for the specific fuse ratings and additional instructions.

Open the hood of your Nissan Micra K12 and locate the headlight assembly. Disconnect the power connector from the back of the bulb, then remove the retaining clip or ring that holds the bulb in place. Gently pull out the old bulb, insert the new one, and secure it with the retaining clip or ring. Finally, reconnect the power connector and test the headlight to ensure it is working properly.

Open the glove compartment and remove any contents. Squeeze the sides of the glove compartment inward to allow the stops to pass the opening, fully lower the glove compartment, and locate the cabin air filter housing cover. Remove the cover by pressing the tabs or screws, and then take out the old cabin air filter. Insert the new filter, ensuring it is properly aligned, and reinstall the cover. Close the glove compartment, and your cabin air filter has been successfully replaced.

Lift the wiper arm away from the windshield and locate the small tab or button on the wiper blade. Press or slide the tab/button to release the old wiper blade from the wiper arm. Align the new wiper blade with the wiper arm and firmly press or slide it until it clicks into place. Repeat the process for the other wiper blade, and then test the wipers to ensure they are functioning correctly.

Start by turning the ignition switch to the "ON" position without starting the engine. Within ten seconds, press and hold the trip/reset button, usually located on the instrument cluster. Continue holding the button until the maintenance reminder light starts flashing and then turns off. Release the button, and the maintenance reminder has been successfully reset.

It is recommended to change the oil in your Nissan Micra K12 every 5,000 to 7,500 miles or every six months, whichever comes first. Regular oil changes help maintain engine performance, extend the life of your engine, and prevent potential damage caused by dirty or degraded oil.

The air filter in your Nissan Micra K12 should be replaced every 12,000 to 15,000 miles or as indicated in the repair manual. A clogged air filter can restrict airflow to the engine, reducing performance and fuel efficiency. Regularly inspecting and replacing the air filter ensures optimal engine performance and protects against potential damage caused by dirt and debris.

It is essential to use a coolant that meets the specifications outlined in the Nissan Micra K12 repair manual. Typically, this would be a long-life ethylene glycol-based coolant, mixed with distilled water in a 50:50 ratio. Using the correct coolant ensures optimal engine cooling, prevents corrosion, and helps maintain the overall health of your vehicle's cooling system.

Your Nissan Micra K12 is designed to run on unleaded gasoline with an octane rating of 87 or higher. Using the recommended fuel ensures optimal engine performance, fuel efficiency, and minimizes the risk of engine knocking or damage. Refer to the owner's manual or the fuel filler door for specific instructions and guidelines.