Land Rover Range Rover (LM) Workshop Manuals and Repair Manuals

To change the engine oil on a Land Rover Range Rover (LM), start by locating the oil drain plug at the bottom of the oil pan. Use a wrench to remove the plug and allow the old oil to drain completely. Once drained, replace the drain plug and proceed to remove the old oil filter. Install a new oil filter and pour in the recommended amount of fresh oil, making sure to check the oil level using the dipstick.

To replace the air filter on a Land Rover Range Rover (LM), locate the air filter housing, which is usually located near the engine. Unscrew or unlatch the housing to gain access to the old air filter. Remove the old filter and clean the housing if necessary. Install the new air filter, making sure it is properly aligned, and secure the housing back in place.

To replace the brake pads on a Land Rover Range Rover (LM), start by safely lifting the vehicle and removing the wheels. Locate the brake caliper, which is secured by bolts, and remove them using a suitable wrench. Once the caliper is loose, carefully remove the old brake pads and replace them with new ones. Ensure that the caliper is properly aligned and secured before reattaching the wheels and lowering the vehicle.

To reset the maintenance reminder on a Land Rover Range Rover (LM), start by turning the ignition switch to the "ON" position without starting the engine. Within 10 seconds, press and hold the reset button located on the instrument cluster until the reminder display begins to flash. Release the button and then press and hold it again until the display shows "RESET" or a confirmation message. Once reset, turn off the ignition and start the vehicle to verify if the maintenance reminder has been cleared.

The recommended tire pressure for a Land Rover Range Rover (LM) varies depending on the specific model and tire size. However, as a general guideline, the tire pressure is typically between 30-35 PSI (pounds per square inch) for most Range Rover models. It's important to refer to the owner's manual or the sticker located on the driver's side door jamb for the precise tire pressure specifications.