Infiniti G35 Coupe Workshop Manuals and Repair Manuals

To bleed the brakes on your Infiniti G35 Coupe, start by locating the brake bleeder valves on each brake caliper. Starting with the farthest wheel from the master cylinder, attach a clear plastic tube to the bleeder valve and submerge the other end in a container filled with brake fluid. Have a helper slowly press the brake pedal while you loosen the bleeder valve slightly to allow air and old fluid to escape. Repeat this process for each wheel, ensuring to top up the brake fluid reservoir as needed.

To change the brake pads on your Infiniti G35 Coupe, start by safely jacking up the vehicle and removing the wheels. Locate the brake caliper and remove the bolts holding it in place. Carefully remove the old brake pads and replace them with new ones, ensuring they are properly aligned. Reinstall the brake caliper and wheels, and then repeat the process for the other wheels.

To change the headlights on your Infiniti G35 Coupe, open the hood and locate the headlight assembly. Depending on the model year, you may need to remove the front grille or other components to access the headlight bulbs. Once accessible, disconnect the electrical connector, remove the retaining clip, and replace the old bulb with a new one. Reassemble the components and test the headlights.

To change the oil in your Infiniti G35 Coupe, first locate the oil drain plug underneath the engine. Use a socket wrench to remove the drain plug and let the old oil drain completely. Once drained, replace the drain plug and remove the oil filter, replacing it with a new one. Finally, refill the engine with the recommended amount and type of oil specified in your Infiniti G35 Coupe automotive repair manual.

To check and fill the coolant in your Infiniti G35 Coupe, first make sure the engine is cool. Locate the coolant reservoir and check the level, which should be between the minimum and maximum marks. If needed, remove the cap and add a mixture of coolant and distilled water as recommended in the automotive repair manual. Be cautious not to overfill the reservoir.

To check the transmission fluid level in your Infiniti G35 Coupe, start the engine and let it warm up to operating temperature. Locate the transmission dipstick, usually near the back of the engine bay. With the engine running, pull out the dipstick, wipe it clean, reinsert it fully, and then remove it again. Check the fluid level on the dipstick, making sure it falls within the recommended range as indicated in the automotive repair manual.

To replace the battery in your Infiniti G35 Coupe, start by opening the hood and locating the battery. Disconnect the negative (-) terminal first, followed by the positive (+) terminal. Remove any retaining brackets or clamps holding the battery in place and carefully lift it out. Install the new battery, making sure the terminals are properly connected. Finally, reconnect the positive (+) terminal first, followed by the negative (-) terminal.

To replace the cabin air filter in your Infiniti G35 Coupe, locate the cabin air filter housing, which is usually located behind the glove compartment. Open the glove compartment and remove any contents inside. Then, release the retaining clips or screws that hold the housing cover in place and remove the cover. Take out the old cabin air filter and replace it with a new one, ensuring proper alignment. Finally, reinstall the housing cover and the glove compartment.

To replace the fuel filter in your Infiniti G35 Coupe, start by locating the fuel filter, which is typically mounted along the fuel lines under the vehicle or within the engine bay. Before removing the fuel filter, make sure to relieve the fuel system pressure by either disconnecting the fuel pump fuse or using a fuel pressure gauge. Once the pressure is relieved, disconnect the fuel lines from the filter and remove any mounting brackets or clamps. Install the new fuel filter, reconnect the fuel lines, and then test for any fuel leaks.

To replace the serpentine belt on your Infiniti G35 Coupe, start by locating the belt tensioner. Use a wrench or a specialized belt tensioner tool to rotate the tensioner and release the tension on the belt. Once the tension is released, carefully remove the old belt from the pulleys. Route the new belt according to the belt routing diagram provided in the automotive repair manual. Finally, rotate the tensioner again and install the new belt onto the pulleys.

To replace the spark plugs on your Infiniti G35 Coupe, start by locating the spark plug wires or ignition coil packs, depending on the specific model year. Disconnect the wires or coil packs and remove any components obstructing access to the spark plugs. Use a spark plug socket and ratchet to carefully remove the old spark plugs. Install the new spark plugs, ensuring the correct gap as specified in the automotive repair manual. Reattach the wires or coil packs and repeat the process for the remaining cylinders.

To reset the maintenance light on your Infiniti G35 Coupe, turn the ignition switch to the ON position without starting the engine. Within 10 seconds, push and hold the trip reset button until the maintenance light starts flashing. Once the light stops flashing, turn off the ignition and then start the engine to verify if the maintenance light has been successfully reset.

When troubleshooting a faulty electrical system in your Infiniti G35 Coupe, it is important to start by checking the fuses and relays related to the specific malfunctioning component. Use a multimeter to test for continuity and ensure proper voltage across the electrical connections. If necessary, consult the wiring diagrams in the automotive repair manual to trace the circuit and identify any potential issues. Additionally, inspecting and cleaning the battery terminals and ground connections can often resolve electrical problems.

The frequency of air filter replacement in your Infiniti G35 Coupe depends on various factors such as driving conditions and air quality. However, as a general rule of thumb, it is recommended to replace the air filter every 12,000 to 15,000 miles or once a year. Regularly inspecting the air filter for dirt and debris is also advisable.

The recommended tire pressure for your Infiniti G35 Coupe can be found in your automotive repair manual. However, as a general guideline, the tire pressure is usually around 32-35 psi for both the front and rear tires. It's important to check and adjust the tire pressure regularly to ensure optimal performance and safety.