Chrysler Grand Voyager Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Chrysler Grand Voyager
The Chrysler Voyager or Chrysler Grand Voyager is a luxury minivan sold by the Chrysler division of American automobile manufacturer Chrysler Group LLC. For most of its existence, vehicles bearing the Chrysler Voyager nameplate have been sold exclusively outside the United States, primarily in Europe and Mexico. The European Chrysler Voyager was initially released in 1988. The European Voyagers were sold with different engines, including diesel engines, which are popular in Europe; and the trim was different. They were also available with manual transmission and a foot operated emergency brake. Since October 2011, vehicle is exported and sold as Lancia Voyager.Chrysler Grand Voyager FAQ's
How do I change the air filter in a Chrysler Grand Voyager?
To change the air filter, first locate the air filter housing, which is usually located on the driver's side of the engine compartment. Remove the housing cover and then remove the old air filter. Replace the old air filter with a new one, making sure it is properly seated, and then replace the housing cover.
How do I check the transmission fluid level in a Chrysler Grand Voyager?
To check the transmission fluid level, park the vehicle on level ground and warm up the engine. Locate the transmission dipstick, which is usually labeled and located near the engine. Remove the dipstick, wipe it clean, reinsert it, and then remove it again to check the fluid level.
How do I jumpstart a Chrysler Grand Voyager?
To jumpstart a Chrysler Grand Voyager, first park the vehicle with the dead battery next to a running vehicle. Connect the positive jumper cable to the positive terminal on the dead battery and then connect the other end of the positive cable to the positive terminal on the running vehicle's battery. Next, connect the negative cable to the negative terminal on the running vehicle's battery and then connect the other end of the negative cable to a metal ground on the dead vehicle, such as a bolt or bracket. Start the running vehicle and let it run for a few minutes before attempting to start the dead vehicle.
How do I replace a headlight bulb on a Chrysler Grand Voyager?
To replace a headlight bulb, first locate the headlight assembly, which is usually behind the front bumper. Remove the electrical connector from the back of the headlight assembly and then twist the bulb counterclockwise to remove it. Insert the new bulb and then reconnect the electrical connector.
How do I replace the alternator on a Chrysler Grand Voyager?
To replace the alternator, first disconnect the battery and then remove the serpentine belt. Remove the electrical connections from the alternator and then remove the bolts holding the alternator in place. Install the new alternator and then reconnect the electrical connections. Reinstall the serpentine belt and then reconnect the battery.
How do I replace the battery in a Chrysler Grand Voyager?
To replace the battery, first locate the battery, which is usually located in the engine compartment. Disconnect the negative cable from the battery and then disconnect the positive cable. Remove the battery hold-down bracket and then remove the old battery. Install the new battery, making sure it is properly seated, and then reconnect the positive cable followed by the negative cable.
How do I replace the brake pads on a Chrysler Grand Voyager?
To replace the brake pads, first remove the wheel and then remove the caliper bolts. Slide the caliper off the rotor and then remove the old brake pads. Install the new brake pads and then slide the caliper back onto the rotor. Reinstall the caliper bolts and then repeat on the other side.
How do I replace the cabin air filter on a Chrysler Grand Voyager?
To replace the cabin air filter, first locate the filter housing, which is usually located behind the glove compartment. Remove the housing cover and then remove the old filter. Replace the old filter with a new one, making sure it is properly seated, and then replace the housing cover.
How do I replace the fuel filter on a Chrysler Grand Voyager?
To replace the fuel filter, first locate the filter, which is usually located under the vehicle near the fuel tank. Use a wrench to loosen the fuel line fittings and then remove the old filter. Install the new filter and then tighten the fuel line fittings. Start the engine and check for leaks.
How do I replace the radiator on a Chrysler Grand Voyager?
To replace the radiator, first drain the coolant from the system. Remove the upper and lower radiator hoses and then remove the bolts holding the radiator in place. Remove the old radiator and then install the new one. Reconnect the hoses and then refill the coolant.
How do I replace the serpentine belt on a Chrysler Grand Voyager?
To replace the serpentine belt, first locate the belt routing diagram, which is usually located under the hood. Use a wrench to release the tension on the belt tensioner and then slide the belt off the pulleys. Install the new belt, following the diagram, and then use the wrench to tighten the tensioner.
How do I replace the spark plugs on a Chrysler Grand Voyager?
To replace the spark plugs, first locate the spark plug wires, which are usually located near the engine. Remove the wire from the spark plug and then use a spark plug socket to remove the old spark plug. Install the new spark plug, making sure it is properly seated, and then reconnect the wire. Repeat on the other spark plugs.
How do I replace the starter on a Chrysler Grand Voyager?
To replace the starter, first disconnect the battery and then remove the electrical connections from the starter. Remove the bolts holding the starter in place and then remove the old starter. Install the new starter and then reconnect the electrical connections. Reconnect the battery.
How do I replace the windshield wiper blades on a Chrysler Grand Voyager?
To replace the windshield wiper blades, lift the wiper arm away from the windshield and then press the release tab on the wiper blade. Slide the blade off the arm and then slide the new blade onto the arm, making sure it clicks into place. Lower the wiper arm back onto the windshield.
What is the recommended oil type for a Chrysler Grand Voyager?
The recommended oil type for a Chrysler Grand Voyager is 5W-30 synthetic oil. It is important to use the recommended oil type to ensure optimal engine performance and longevity. Be sure to check the owner's manual for specific oil recommendations.
Chrysler Grand Voyager on Amazon
Chrysler Grand Voyager Workshop Manual
- (Free)
-
- Chrysler Grand Voyager 2001 Workshop Manual
- (4,284 Pages)
- (Free)
-
- Chrysler Grand Voyager 2002 Workshop Manual
- (4,426 Pages)
- (Free)
-
- Chrysler Grand Voyager 2003 Workshop Manual
- (4,298 Pages)
- (Free)
-
- Chrysler Grand Voyager 2004 Workshop Manual
- (4,903 Pages)
- (Free)
-
- Chrysler Grand Voyager 2005 Workshop Manual
- (5,521 Pages)
- (Free)
Related Models
