Buick Le Sabre Workshop Manuals and Repair Manuals

Every Manual available online - found by our community and shared for FREE. Enjoy!

Buick Le Sabre

The Buick LeSabre, French for "the sabre", is a full-size upscale car manufactured by the Buick division of General Motors from 1959-2005. The LeSabre nameplate made its first appearance on the 1951 Le Sabre show car. In addition to being Buick's entry level vehicle, the LeSabre was consistently Buick's best selling full-size car. LeSabre carried the title of America's Best-Selling Full-size Car until its demise at the end of the 2005 model year. The car was replaced in 2006 with the midsized, more modern Buick Lucerne.

Buick Le Sabre FAQ's

How do I check the brake fluid in a Buick Le Sabre?

To check the brake fluid in a Buick Le Sabre, locate the brake fluid reservoir under the hood. Remove the cap and check the fluid level, which should be between the “MIN” and “MAX” lines. If it is low, add brake fluid that meets the DOT 3 or DOT 4 specification. Do not overfill the reservoir.

How do I replace the air filter in a Buick Le Sabre?

To replace the air filter in a Buick Le Sabre, locate the air filter housing under the hood. Release the clips or screws securing the housing and remove the old air filter. Clean the housing and install a new air filter, making sure it is properly seated and secured.

How do I replace the battery in a Buick Le Sabre?

To replace the battery in a Buick Le Sabre, turn off the engine and open the hood. Locate the battery and remove the negative cable, then the positive cable. Remove the battery hold-down clamp and lift out the old battery. Clean the battery tray and install the new battery, securing it with the hold-down clamp. Reconnect the positive cable, then the negative cable.

How do I replace the cabin air filter in a Buick Le Sabre?

To replace the cabin air filter in a Buick Le Sabre, locate the filter housing under the dashboard on the passenger side. Release the clips or screws securing the housing and remove the old filter. Clean the housing and install a new filter, making sure it is properly seated and secured.

How do I replace the fuel filter in a Buick Le Sabre?

To replace the fuel filter in a Buick Le Sabre, locate the filter under the car near the fuel tank. Use a wrench to disconnect the fuel lines from the filter and remove the old filter. Install a new filter, making sure it is in the correct orientation and the fuel lines are properly connected.

How do I replace the headlights in a Buick Le Sabre?

To replace the headlights in a Buick Le Sabre, open the hood and locate the headlight assembly. Remove the retaining clips or screws and pull out the assembly. Disconnect the wiring harness from the back of the assembly and remove the old bulb. Install a new bulb and reattach the wiring harness and assembly.

How do I replace the oxygen sensor in a Buick Le Sabre?

To replace the oxygen sensor in a Buick Le Sabre, locate the sensor under the car near the exhaust pipe. Use a wrench or socket to loosen and remove the old sensor, then install the new sensor using a torque wrench to the correct specification. Reconnect the wiring harness and clear any diagnostic trouble codes from the engine control module.

How do I replace the serpentine belt in a Buick Le Sabre?

To replace the serpentine belt in a Buick Le Sabre, locate the belt tensioner and use a wrench or socket to release tension on the belt. Remove the old belt and route the new belt according to the diagram under the hood. Use the tensioner to apply tension to the new belt, then check the alignment and tension.

How do I replace the spark plugs in a Buick Le Sabre?

To replace the spark plugs in a Buick Le Sabre, locate the spark plug wires and remove them from the spark plugs. Use a spark plug socket and ratchet to remove the old spark plugs and install the new ones, making sure to gap them correctly. Reattach the spark plug wires, making sure they are in the correct order.

How do I replace the windshield wiper blades in a Buick Le Sabre?

To replace the windshield wiper blades in a Buick Le Sabre, lift the wiper arm away from the windshield. Press the release tab on the blade and slide it off the arm. Install the new blade, making sure it is properly seated and secured. Repeat for the other wiper blade.

What is causing my Buick Le Sabre to overheat?

Several factors can cause a Buick Le Sabre to overheat, including a faulty thermostat, a clogged radiator, a malfunctioning water pump, or low coolant levels. It is important to address the issue promptly to prevent engine damage. A professional mechanic can diagnose and repair the problem.

What is causing my Buick Le Sabre to stall?

Several factors can cause a Buick Le Sabre to stall, including a faulty fuel pump, a clogged fuel filter, a malfunctioning ignition system, or a vacuum leak. It is important to address the issue promptly to prevent accidents and further damage. A professional mechanic can diagnose and repair the problem.

What is causing my Buick Le Sabre to vibrate while driving?

Several factors can cause a Buick Le Sabre to vibrate while driving, including unbalanced tires, worn suspension components, or a damaged driveshaft. It is important to address the issue promptly to prevent accidents and further damage. A professional mechanic can diagnose and repair the problem.

What is the correct tire pressure for a Buick Le Sabre?

The correct tire pressure for a Buick Le Sabre is 30 PSI for the front tires and 32 PSI for the rear tires. It is important to check the tire pressure regularly and adjust it as needed. Overinflated or underinflated tires can affect handling, fuel economy, and tire wear.

What is the recommended oil type for a Buick Le Sabre?

The recommended oil type for a Buick Le Sabre is 5W-30. It is important to use oil that meets the GM standard GM6094M. It is recommended to change the oil and filter every 7,500 miles or six months, whichever comes first.

Buick Le Sabre Manuals Index

Buick Le Sabre Workshop Manual

Buick Le Sabre Owners Manual

Buick Le Sabre Misc Document

Related Models