BMW 7 Series Workshop Manuals and Repair Manuals

Every Manual available online - found by our community and shared for FREE. Enjoy!

BMW 7 Series

The Pontiac Phoenix is a compact car sold from 1977 to 1984 by the Pontiac division of General Motors. There were two generations of the Phoenix, both based on popular Chevrolet models, and both using the GM X platform designation. The rear wheel drive Phoenix was introduced in 1977 as the top-level trim of the Pontiac Ventura, and replaced the Ventura entirely in 1978. In 1980, the Phoenix was downsized and moved to front wheel drive, and was available as 2-door coupe or a 5-door hatchback. The Phoenix was replaced by the Grand Am in 1985.

BMW 7 Series FAQ's

How do I bleed the brakes?

To bleed the brakes on your BMW 7 Series, start with the brake furthest from the master cylinder. Open the bleeder valve and have a helper press the brake pedal several times. Close the valve and repeat the process on each brake, working your way towards the master cylinder. Check the brake fluid level periodically and add more as needed.

How do I change the oil filter?

To change the oil filter on your BMW 7 Series, first locate the filter housing underneath the engine. Use a filter wrench to loosen the filter housing, and then remove the old filter. Before installing a new filter, lubricate the rubber gasket with a small amount of fresh oil.

How do I check the transmission fluid?

To check the transmission fluid on your BMW 7 Series, first make sure the car is on level ground and the engine is running. Locate the transmission dipstick, which is usually near the back of the engine. Pull out the dipstick and check the fluid level against the markings on the dipstick.

How do I replace the air filter?

To replace the air filter on your BMW 7 Series, first locate the air filter housing. Use a screwdriver or socket wrench to remove any screws or clamps holding the housing in place, and then lift off the housing cover. Remove the old air filter and replace it with a new one, making sure it is properly seated in the housing.

How do I replace the alternator?

To replace the alternator on your BMW 7 Series, first disconnect the negative battery cable. Remove any belts or pulleys that are in the way, and then disconnect the wiring harness and mounting bolts from the alternator. Install the new alternator in reverse order, making sure all connections are secure.

How do I replace the battery?

To replace the battery on your BMW 7 Series, first remove the negative cable from the old battery, followed by the positive cable. Remove any mounting brackets or screws holding the battery in place, and then lift out the old battery. Install the new battery, starting with the positive cable and then the negative cable.

How do I replace the brake pads?

To replace the brake pads on your BMW 7 Series, first remove the wheel and then the brake caliper. Use a C-clamp or piston retractor tool to compress the piston, and then remove the old brake pads. Install the new brake pads and reassemble the caliper and wheel.

How do I replace the fuel filter?

To replace the fuel filter on your BMW 7 Series, first locate the filter under the car near the fuel tank. Use a wrench to loosen the mounting bolts and then disconnect the fuel lines from the filter. Install the new filter and reconnect the fuel lines and mounting bolts.

How do I replace the headlights?

To replace the headlights on your BMW 7 Series, first remove the headlight cover by turning the retaining clips or screws. Disconnect the wiring harness from the back of the headlight, and then remove the old headlight. Install the new headlight and reconnect the wiring harness, and then replace the headlight cover.

How do I replace the serpentine belt?

To replace the serpentine belt on your BMW 7 Series, first locate the belt tensioner and use a wrench to release the tension on the belt. Slip the old belt off the pulleys and install the new belt, making sure it is properly lined up on all the pulleys. Release the tensioner to tighten the belt.

How do I replace the spark plugs?

To replace the spark plugs on your BMW 7 Series, first locate the spark plug wells on the engine. Use a socket wrench to remove the old spark plugs, and then gap the new spark plugs according to the manufacturer's specifications. Install the new spark plugs, tightening them to the correct torque.

How do I replace the thermostat?

To replace the thermostat on your BMW 7 Series, first drain the coolant from the engine. Remove the thermostat housing and then the old thermostat. Install the new thermostat, making sure it is properly seated, and then reassemble the housing and refill the coolant.

How do I replace the water pump?

To replace the water pump on your BMW 7 Series, first drain the coolant from the engine. Remove any hoses or belts that are in the way, and then disconnect the mounting bolts from the water pump. Install the new water pump and reconnect all hoses and belts, and then refill the coolant.

How do I troubleshoot electrical problems?

To troubleshoot electrical problems on your BMW 7 Series, first check the fuses and relays to make sure they are all functioning properly. Use a multimeter to check the voltage and continuity of any suspect electrical components, such as sensors or switches. Check all wiring connections for signs of damage or corrosion.

What is the recommended tire pressure?

The recommended tire pressure for your BMW 7 Series is listed on the label inside the driver's door. It is important to maintain the correct tire pressure to ensure optimal handling and fuel efficiency. Check the tire pressure regularly, especially before long trips.

BMW 7 Series Manuals Index

BMW 7 Series Workshop Manual

Related Models

BMW 7 Series on Amazon

BMW 7 Series (E38) Service Manual: 1995, 1996, 1997, 1998, 1999, 2000, 2001: 740i, 740il, 750il